How Do You Winterize An Inground Pool With A Sand Filter?

How do you winterize a pool with a sand filter?

Sand Filter System Winterizing TipsThe first thing you should do when winterizing your sand filter system is to perform a backwash.

After a backwash and rinse, place the valve to the “winterize” setting on the top mount valve.

Next, you’re going to have to completely drain all the water from the filter tank.More items….

Can I leave my inground pool empty over winter?

It’s not good to leave your pool empty when the weather gets cold. … You may naturally assume it’s best to completely drain your pool of water for the winter months, because you fear the water will freeze and cause damage. Actually, it’s not good to leave your pool empty when the weather gets cold.

How far should I drain my inground pool for winter?

It’s acceptable to drain the pool a few more inches below that if you live in an area that gets heavy precipitation during the winter months. Some pool professionals even suggest draining the water to as much as 6 inches below the skimmer — about the level of the bottom of the pool’s return jet.

What happens if you don’t winterize your pool?

Algae Infestation Failing to winterize your pool – combined with the steps above – will lead to an unsightly and expensive to clean pool. … Once you actually want to use your pool again, you’ll likely have to drain the water out of the pool completely and the replace.

What chemicals do you put in pool for winter?

Chlorine levels need to be at 1-3ppm (parts per million) in your pool for the cold winter months. Most pool supply stores recommend using a Chlorine or Non-Chlorine Shock treatment before you close the pool to balance the water and make sure that it’s ready to sit all winter.

Can I leave pool pump outside?

Keep it on a low shelf so it won’t fall or roll. If you keep your motor outdoors all winter, you could build a ‘lean-to’ with lumber or plastic for snow, rain and tree branches, but keep good air flow around the motor, and don’t wrap it in plastic, which traps moisture inside the motor.

How do you drain an inground pool below skimmer?

If your main drain is connected to the skimmer, and you have two holes in the bottom of the skimmer – then it is more difficult to pump below the skimmer. The easiest method is to connect a threaded hose adapter into the hole which goes to the pump, and connect a primed, “tight” vacuum hose to it.

Can I leave my sand filter out all winter?

The Filter Bring your filter indoors for winter storage. If the weight of the sand makes this too difficult, you can leave it outside if you remove all the drain plugs. With the plugs removed, freezing water or condensation that builds up inside the filter tank won’t crack it.

Should I cover my pool equipment in the winter?

No, but winter covers protect your pool from stains, algae growth and poor water balance that could damage pool surfaces. … However, if you want to close the pool, but keep it uncovered all winter, or if you need to delay purchasing a new cover until next fall – here are the steps we took to do it for our customer above.

How often should a pool sand filter be changed?

every 3-5 yearsOn average, sand should be replaced every 3-5 years. This may be longer if the pool stays clear, or shorter, if the filter runs all the time. The jagged edges of the sand wear down and become smooth as the sand ages.

How much does it cost to winterize a pool?

Summary: Professional Pool Closing Prices Most homeowners will spend between $125 and $375 to have their pool winterized by a professional. The national average reported cost is $232. The minimum cost a homeowner paid was $50 while the maximum reported cost was $700.

How long can you keep an inground pool empty?

Knowing the construction of your pool will give you a better idea of how long you can leave it drained; some can be left empty for more extended periods, while other pools cannot be left drained for more than 15 minutes.

Is it OK to leave an inground pool empty?

Draining or emptying your pool of water can create a number of financial and structural headaches, including: Cracking the pool’s shell. Damaging the interior lining or surface. Damaging the pool’s coping and surrounding paving or timber work.